How to Configure the Client Mode on the Pharos device?

Definition:In this mode, the device actually serves as a wireless adapter to receive the wireless signal from root AP or Station. In the case, wired devices can access the network provided by root AP or Station through connecting to Client.
Take CPE as an example.  
Access web management page of CPE
Please follow this link to access the web interface of CPE:
Note:CPE210 is a 2.4GHz device which can only  connect to 2.4GHz wireless networks;CPE510 is a 5GHz  device which can only connect to 5GHz wireless networks.Here we take CPE510 as example in this article. 
Run Quick Setup
Step 1:
Go to Quick Setup-> Choose “Client -> Click Next
Step 2:
The default IP Address of CPE is,we can change it to other IP addresses to fit in the main router’s network. For example, if the main modem/router’s IP Address is,we can set up the CPE510 as 192.168.1.* (*=2~254)Subnet Mask .
It is also fine to leave it as the default value if you are not sure about the main router’s IP address, then click Next.
 Step 3:
Click Survey
It will scan for all the available  wireless networks, please find the main router’s network, check the security type and click Connect. Here we take TP-Link_5GHz-C2FA7C as an example.
Step 4:
Choose the same Security type as the main router,and type in the same wireless password/Network Security Key of the main router for the PSK Password. Please refer to Main Router’s Manufacturer for details if you are sure about the wireless password/network security key->Click Next.
Step 5:
Click: Finish, and wait for the settings to take effect, it takes about 1 minute.
Relocate the CPE
You may now unplug the computer from the LAN port of the PoE adapter,and connect any device to that LAN port to enjoy the internet.
Final Computer Setup Reversion(For Windows OS)
We need change the IP settings back of the computer after the configuration.
Please find Local Area Connection/Ethernet on the computer, if you cannot remember the procedure, please refer to the FAQ again.
How to login to the Pharos' web management page?
Go to Properties Internet Protocol Version 4(TCP/IP) Select “Obtainan IP address automatically” and “Obtain DNS server addressautomatically
Click OK to exit
Click OK again to apply the settings.
Final Computer Setup Reversion (For Mac OS X)
Go to the Apple->System Preferences->Network-> Highlight Ethernet ->Configure IPv4: Using DHCP.
Click Apply.
Get to know more details of each function and configuration please go to Download Center to download the manual of your product.
This Article Suits for:
WBS510 , WBS210 , CPE520
User Application Requirement | Updated 05-25-2016 06:16:09 AM